. MAINTENANCE MAINTENANCE PROCEDURE of the core. a Adjustment WARNING 4 - 33 CHECK AND ADJUST RU (Machine equipped with rub The wear of the rubber shoe will vary with the work conditions an d type of soil, so inspect t he wear and track t ension whenever necessary. Stop maintenance. In particular, on new machin es or after new tracks have been in stalled and th e tension ha s been s et to the sp ecified value, the track tension will b ecome loose in the first 5 to 30 ho urs when the machine h as been u sed for a certain amount of repeated travel.
If the track tension is a djusted frequently until the initial lo oseningno lon ger occurs, this will p revent the shoes from coming off due to insuff If operations are carried out when the rubber shoe is loose, the track will com e off and it will cause prematur e wear Checking 1. Run the engine at low distance equal to the len machine. 2. Choose wooden block (3 roller (2), then place it on 3. Measure the maximum the rubber shoe and the Standard deflection Deflection "a" should idling, move the machine forward gth of track on ground, then stop t ) that will reach from idler (1) to carr top of the track.
deflection between the top surface bottom surface of the wooden bloc be 1 to 3 mm (0.039 to 0.118 in). If the track tension is not at t he standard value, adjust it in the f ollowing man There is danger of the plug flyin g out under the high internal pressure the grease. When loosening plu g (1), never loosen it more than one tu Never loosen any part other tha n plug (1). Never put your face in line w the mount of plug (1). If the Rubber shoe tension is not relieved by this procedure, please cont your Komatsu distributor.