Komatsu — CHECK AND ADJUST RUBBER SHOE TENSION

. MAINTENANCE MAINTENANCE PROCEDURE Increasing Track Tension NOTICE Loosening Track Tension WARNING given below. If is not 4 - 34 The standard value i s low, so be careful not t o tighten the rubber sh oe too Prepare a grease gun. 1. 2. 3. 4. 1. Pump in greas e through grease fittin g (2) with a grease p ump. 2. To check if the tension is correct, ru n the engine at low i dling, move the mac hine slowly forward (b y an amoun t equal to the length of track on ground), then stop the machin e. 3. Check the rub ber shoe tension agai n, and if the tension is not correct, adjust it again. 4.

If the tension is still low after supplie d grease, th e rubber shoe needs to be re placed or the seal in the cylinde r needs to be replaced. Ask your Komatsu distribu tor for replacement. I t is extremely dange rous to release the gre ase by any m ethod ex cept relieved by this proc edure, please contact yo ur Komatsu d istributo r. the proced the track te nsion i 1. Loosen plug (1 ) gradually to release the grease . ne turn. 2. When loosenin g plug (1), turn it a m aximum of o ne turn. 3. If the grease d oes not come out sm oothly, mov e the ma chine forwards and b ackwards a short dis 4. Tighten plug (1 5.

To check if the tension is correct, ru n the engine at low i dling, move the mac hine slowly forward (b y an amoun t equal to the length of track on ground), then stop the machin e. 6. Check the rub ber shoe tension agai n, and if the tension is not correct, adjust it again. 7. Check the trac k tension again, and if the tension is not co rrect, adjust it again.