. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE gauge. control lever to the neutral idle at a low speed for 2 to 3 4 - 58 5. Open dust cover (1) fully until it is secured in position. (For details of the method of op ening and closing the cover with the lock, see Section "In Case Cover (PAGE 3-28)") of Engine Rear Cover and Dirt plate (3) to the outside. 6. Loosen bolts (2), then remove 7. Remove the cap from oil fille pressure. Set the oil container under th Using the handle, remove dr r (F), and release the internal e drain plug under the machine. 8. ain plug (P) and drain the oil. Check the O-ring installed to plug (P), and if it is damaged, replace the O-ring.
After draini ng the oil, tighten drain plug (P). Tightening torque: 68.6 ± 9.81 N·m (7 ± 1 kgf·m, 50.6 ± 7.2 lbft) T ake care not to get oil on you rself when you remove drain plug (P). 9. Loosen hose clamp (4), remov e hose (5), then remove bolt (6) and take out strainer (7). Remove any dirt stuck to str diesel oil or flushing oil. If str with a new one. Secure strainer (7) with bolt ainer (7), then wash it in clean 10. ainer (7) is damaged, replace it (6), then install hose (5) and clamp (4). 11. secure it in position with hose 12. Open the engine rear cover an d cooling cover. For details, see Section "COOLING COVER ( PAGE 3-29)". 13.
Add the replacement amount of oil through oil filler (F). Check that the oil level is between the H and L lines on the sight 14. Extend the boom, arm, and b ucket cylinder fully as shown in the diagram on the right, rem ove the oil filler cap, then install ide of the tank. the cap and pressurize the ins NOTICE Be s ure to pressurize the hydraulic tan k. If it is not pressurized, the pump will suck in air, and this will adversely affect the equipment. 15. After replacing the oil, set ea positionand run the engine i minutes, then start the normal