Komatsu — TRAVEL MOTOR

TRAVEL MOTOR STRUCTURE, FUNCTION, & MAINTENANCE STANDARD OPERATION OF BRAKE VALVE The brake valve consists of a suction safety valve (18A), counterbalance valve (18) in a circuit as shown in the diagram on the right. (Fig. 1) The function and operation of each component is as given below. 1) Counterbalance valve, check valve Function When traveling downhill, the weight of the machine makes it try to travel faster than the speed of the motor. As a result, if the machine travels with the engine at low speed, the motor will rotate without load and the machine will run away, which is extremely dangerous.

To prevent this these valves act to make the machine travel according to the engine speed (pump discharge amount). SAP03482 OR 08897 Operation when pressure oil is supplied When the travel lever is operated, the pressurized oil from the control valve is supplied to port PA . It pushes open suction safety valve (18A) and flows from motor inlet port MA to motor outlet port MB . However, the motor outlet port is closed by suction safety valve (18B) and spool (19), so the pressure at the supply side rises. (Fig. 2) The pressurized oil at the supply side flows from orifice E1 and E2 in spool (19) to chamber S1 .

When the pressure in chamber S1 goes above the spool switching pressure, spool (19) is pushed to the right in the direction of the arrow. As a result, port MB and port PB are connected, the outlet port side of the motor is opened, and the motor starts to rotate. (Fig. 3) PC210/240-7K 10-107