Komatsu — STARTING ENGINE

. OPERATION OPERATION OPERATION OPERATION lamp (3) after approx. 12 seconds, 6. When the engine starts, release the key in starting switch (2). The key will return automatically to the ON position (B). 7. When the engine rotation stabilizes, return to the low idle (MIN) position of fuel control dial (1) and then carry out the warming-up operation. REMARK Regardless of the ambient temperature, if the key in starting switch (2) is turned from OFF position to left, preheating pilot lamp (3) will light up and preheating will start. (Preheating continues while the starting switch is held at the left.) For the details of the preheating time, see the table in Step 5.

While preheating is being carried out, the preheating pilot lamp (3) lights up to show that preheating is being carried out. After it lights up for 36 seconds, it flashes for 16 seconds and goes out. When it goes out, complete the preheating immediately. If the engine does not start with the above operation, wait for about 2 minutes, and repeat steps from Step 3. And 4. 3 - 79 4. Keep in t his condition goes out. (Pre-heating lamp goe s out.) until engine re-heating pilot and the 5. When preheatin g pilot lamp (3) goes off, turn the key of ignition switch (2) to the START po sition (C) to crank the engine.

The t ime that preheating pilo t lam p ( 3) tays on changes according the as hown in the able below Ambient temperature Preheat time 0°C to -10°C (32°F to 14°F) 0 to 15 seconds -10°C to -20°C (14°F to -4°F) 15 to 30 seconds -20°C to -30°C (-4°F to -22°F) 30 to 50 seconds