. OPERATION OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE WARNING WARMING UP OPERATIONS suddenly operate the levers when the Always perform the warming-up (4) flashes or the buzzer sounds 1. Turn fuel control dial (1) to the center position between low idling (MIN) and high idling (MAX) positions and run the engine at a mid-range speed for 5 minutes under no load. 2. After warm-up run is completed, check gauges and caution lamps for proper operation. If any abnormality is found, repair it. Continue to run the engine at light load until engine water temperature gauge indicator (2) falls within the green range. 3. Check for abnormal exhaust gas color, noise, or vibration.
If any problem is found, contact your Komatsu distributor. 3 - 80 If there has been any Emergency stop, abnormal actuation or trouble, turn th e starting switch key to the OFF position . If the work equipment is operated without sufficiently warming the machine u p, response of the wo rk equipment to mo vement of the control lever will be slow, and the work equipment may not respond as the operator desir es, so always perfo rm the warming-up operation. Particularl y in cold areas, be sure the warming-up ope ratio n is completed. NOTICE Do not perform operations or su hydraulic oil is at a low temperat operation until the hydraulic oil te range.
This will help extend the m Do not suddenly accelerate the en operating temperature. Do not run the engine at low or hi will cause oil leaks from the turbo If it is necessary to run the engin time or run the engine at a mid-ra If engine oil pressure caution la intermittently, stop the engine an