. OPERATION OPERATION IN COLD AREAS 3 - 81 1. Turn fu low idling ( MIN) and high idling ( MAX) positions and run the engine at a mi d-range speed for 10 minutes under no load 2. Operat e blade control leve r (3) to the RAISE po sition, then 3. keep th e blade raised to the maximum height and continue to relieve Finally, the circuit for 10 min operate blade contr utes. ol lever (4) and ripper control lever to oper If the o ate the blade and rip il temperature in th per cylinders several times. e work equipment is not properly lag in the response of the work mes. ot properly raised, there will be a time equipm ent and steering. 4.
After w arm-up run is comp leted, check gauges a nd caution lamps f or proper operation. If any abnormality is fo und, repair it. e to run the engine at light load until engine water Continu temper ature gauge indicato r (2) falls within the gre en range . REMARK I f the power train oil temperature is not raised sufficiently , it will take longer to ac celerate to the maxi mum speed. 5. Check for abnormal exhau st gas color, noise, or vibration. If any pro blem is found, conta ct your Komatsu distrib utor.