. OPERATION OPERATION RIPPER OPERATION rear. speed (F1 or F2). 3 - 105 EFFECTIVE MET The optimum dig ging angle for the shank is whe n the shank is he ground (ripping angle: 45° to In comparatively soft rock (seismic velocity: 1500 m/s or below), to carry out ripping with the sha nk tilted to the On comparativel rear, there will be excessive we ar of the point self-sharpening ability will be lo During ripping op erations, if the shoes slip becau se of boulders the bedrock, use the tilt cylind a stone, advance the machine at a fixed gear REMARK When raising bo ulders or digging up rockbed, do not put the neutral.
If the transmission is in neutral, the transmission in reaction of the til operate the mac t cylinder will push the machine back. Always hine with the transmission in FO RWARD. Choosing a suita ble ripper point to match the type of rock is one of the most impo Ripper points are the most suitabl "PROCEDURE 6-4)". rtant elements in using the ripp er effectively. available for different types of r ock, so select e ripper point from the list. For details, see FOR SELECTING RIPPER POINT (PAGE r details, see DIGGING UP BOULDERS OR ROCKBED During ripper operat ions, if stubborn boulders or rock bed cause the travel speed to bec ome slower, operate the tilt cylinder to dig up . the boulder/rockbed