. OPERATION OPERATION to the the "PULL OUT" (F)Front of the machine 3. Move the ripper up or down to set to the desired shank position. REMARK Align mark of ripper (A) with top surface of holder (B). (C) (D) (E) Depth Max. Depth intermediate Depth min. 3 - 106 OPERATING ON SLOPES When using the variable ri pper, adjust the length of the tilt cylinder to select dimension L METHOD OF OPERATING PIN PULLER (Machines e quipped with giant-shank ripper) 1. 2. 1. Stop the place and ground. 2. Operate pin pulle switch to position (1) and r emov e the mounting pin the shank