. OPERATION OPERATION ADJUSTING POSTURE OF WORK EQUIPMENT WARNING BLADE ADJUSTMENT TILTING THE TILTDOZER 3 - 113 When adjusting, it is da ngerous if the work equipment is moved by mistake. Set the work equipme nt in a safe condition, then stop the engine and lock the work equipment securely with the work e quipment lock NOTICE of tilt is 1065 mm (3.6 ft). e is used.) 1065 mm (3.6 ft) for the tilt. The maximum amount (When the semi-U blad Be sure not to exceed 1065 mm (3.6 ft) for the tilt. Tilt exceeding the maxi mum limit imposes unnecessa ry forces on to sections.
T his may cause d amage to the machine According to the ope ration of the blade control le ver, the fo llowing tilt amount can be ob tained: (25.6 in) or more 5.6 in) or more d, do as follows. Right side: 650 mm Left side: 650 mm (2 If more tilt is require Use bar handle (2) i nstalled to the left brace to t urn brace (1) and change the length (A ) of the brace. This makes it possible t o obtain a maximum tilt of 10 65 mm (42.0 in). between joints A: 1552 mm (61.1 in) Standard distance between joints A: 1552 m m (61.1 in) ADJUSTING SHIM IN BLADE CYLINDER CAP Set the standard shi m adjustment in the blad e cylinde r cap t o 4 mm (0.16 in). lance the wear of the cap and the ball at the .
Remove shims to ba lance the wear of the c ap a nd t he ba end of the piston rod The proper clearanc e to be maintained with the shim s is 0. 2 to 0.5 mm (0.008 to 0.02 in ).