Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUSTING BRACE WARNING (0.04 in). play. 3 - 114 If mainte nance is carried out with the engin e running, always have one worke r sitting in the operator's seat while another worke carries o ut the maintenance. Both workers must mutually confirm the safety during the operation. Adjustm ent can be carried out more e asily if the engine is started, the inch ing operation used to carry ou t tilting to the left and right, and the blade shaken up and down wh ile turning the brace handle (1).

Whe It is eas y to carry out the adjustment if the blade is set on top of a block a nd the brace handle (1) is turne REMARK When operated in this way, the blade is tilted, so the handle gradual ly becomes heavier. When this happens, return the blade from th e tilt position to the horizontal p osition and turn the handle n above. again a ccording to the procedure give SHIM ADJUSTMENT Adjust t the axia he thickness of shim so that th l direction (shown by the arro e ball joint play (7 points) in w) does not exceed 1 mm move shim (1) and tighten bolts (2) to eliminate the ball joint . asure clearance "A" and remove bolts (2). all shim (1) having its thickness of "A" mm to "A + 1" mm in.

to "A + 0.04" in) in place with bolts 2. asure clearance "A" and remov all shim (1) having its thicknes in. to "A + 0.04" in) in place wi firm that ball joint can move sm oothly after tightening bolts.