Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUSTING RIPPER a hand tip 3 - 115 ADJUSTING DIGGIN Mounting pin holes a re provided in the shank an d these are us ed according to the desired di gging depth . For no use , use the bottom hole, and when p articularly deep digging is needed, use the top hole. For the method of c hanging the depth of digging,see " METH OD OF OPERATIN PIN PU LLER (PAGE 3-10 (Machines equippe d with multi-shank r 1. Place a pointed object on the tip hammer to rem ove from the oppos ite side. 2. Remove pin (2) and change the po sition of the shank hol 3. Insert pin (1) pa rtially by hand then knock it in with a ham The pin is ma de of one piece, s then knock it in with a hammer.

REPLACING POINT AND PROTECTOR To protect the shan k, if the protector and point installed to th em. nd point installed to th are worn, replace th Place a pin remove r on the pin marked by the a rrow, t hen hit a hammer to remov e from the opposit e side. REMARK The pin is a unitized type, so insert the pin parti ally by hand, then knock i t in fully with a ha