Komatsu — HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC

. MAINTENANCE OUTLINES OF SERVICE KOWA ANALYSIS ITEMS Measurement of density of metal wear particles This uses an ICP (Inductively Coupled Plasma) analyzer to measure the density of iron, copper, and other metal wear particles in the oil. early detection of failures. OIL SAMPLING Sampling interval 250 hours: Engine 500 hours: Other components 4 - 7 It is recommended to sh orten the lubrication interval when the m achine is ope rated under ha rd working co nditions or in a dusty or wet jobs ite. Grease fittings not listed in the inspection and maintenance se ction are gre ase fittings tha t are used at the time of overhaul, so there is When using the machin screeching.

no need to grease these points. e after it has been in storage for a long time, carry o ut greasing if th ere is any stif fness or e old grease that is pushed out when greasing. Always wipe off all of th e old grease that is pushed out when Be particularly careful to wear of the rotating part wipe off the old grease in places whe re sand or dir t sticking in the grease wou ld cause s. CARRYING OUT KOWA (Komatsu Oil Wear Analysis ) KOWA is a maintenance s ervice that makes it possible to prevent machine fail ures and downt ime. With KO WA, the oil is periodically sampled and analyzed. This enables early detection of wear of the machine drive parts a nd other problems.

We strongly recommend y ou to use this service. The oil analysis is carried out at actual cost, so the cost is low, and the results of the analysis a re reported together with recommendations which will reduce repa ir costs and machine downtime. Measurement of quantit y of particles rticle Quantifier Index) measurer t iron particles of 5µm or more, enablin Others Measurements are mad fuel in the oil, and dyna e of items such as the ratio of water in the oil, dens ity of the antifr eeze coolant , ratio of mic viscosity, enabling a highly precise diagnosis of the machine's health.