. MAINTENANCE OUTLINES OF SERVICE For further details of KOWA, please contact your Komatsu distributor. 4 - 8 Make sure that the oil is well mixed be Perform sampling at regular fixed inter Do not perform sampling on rainy or w STORING OIL AND FUEL r other impurities from getting in. Keep indoors to prevent any water, dirt, o When keeping drum cans for a long period , put the drum on its side so that the filler port of the drum s is at the side to prevent moisture from being sucked in. If drums have to be stored outside, cover them with a waterproof sheet or take other measures to protect them.
To prevent any change in quality during lo ng-term storage, be sure to use in the order of first in - fir st out (use the oldest oil or fuel first). FILTERS Filters are extremely important safety pa rts. They prevent impurities in the fuel and air circuits from entering s. see the Operation and Maintenance Manual. important equipment and causing problem Replace all filters periodically. For details, However, when working in severe conditi ons, replace the filters at shorter intervals according to t he oil and fuel (sulfur content) being used. e) and use them again. Always replace with new filters. Never try to clean the filters (cartridge typ e) and use them again.
Always replace with new filters. When replacing oil filters, check if any met al particles are attached to the old filter. If any metal parti cles are found, contact your Komatsu distributor. st before they are to be used. strongly recommended. Do not open packs of spare filters until ju Use of Komatsu genuine filter elements is OUTLINE OF ELECTRIC SYSTEM It is extremely dangerous if the electrical e quipment becomes wet or the covering of the wiring is d amaged. This will cause an electrical short circuit and m ay lead to malfunction of the machine. Do not wash th e inside of the operator's cab with water. When washi components.
ng the machine, be careful not to let water get into the electrical Service relating to the electric system is c hecking fan belt tension, checking damage or wear to th e fan belt and checking battery fluid level. er than those specified by Komatsu. Never install any electric components oth External electro-magnetic interference ma y cause malfunction of the control system controller, b efore installing a radio receiver or other wireless equipm ent, contact your Komatsu distributor. clean the electric system to prevent corrosion. nect it to the special power source connector. to the fuse, starting switch, or battery relay.
When working at the seashore, carefully When installing electrical equipment, con Do not connect the optional power source