. MAINTENANCE SERVICE PROCEDURE NOTICE WHEN LOOSENING TENSION WARNING NOTICE 4 - 31 WHEN INCREASING TENSI 1. First remove the bol t (1) and then remove the c W hen removing cover (2 ), be careful not to let any dirt get inside. T here is a safety label st uck to the back of cover (2). B e careful not t 2. Pump in grease thro ugh the grease fitting (3) w ith a grease pump. 3. To check that the co rrect tension has been ach ieved, move the machine backwards a 4. Check the track ten sion again, and if the tensio n is not correct, 5.
Continue to pump in grease until S becomes 60 0 mm (23.6 in If the tension is still l oose, the pin and bushing a re excessive worn, so they mus contact your Komat It is extremely dangerous t o release the grease by any m ethod except th If track tension is not reliev ed by this procedure, contact your Komatsu 1. Remove both bolts ( 1), then remove cover (2). W hen removing cover (2 ), be careful not to let any dirt get inside. T here is a safety label st uck to the back of cover (2). B e careful not t 2. Loosen plug (4) gra dually to release the grease 3. Turn plug (4) a maxi 4. If the grease does n ot come out smoothly, mov e the machin 5. backwards and forw Tighten plug (4).
ards a short distance. 6. To check that the cor rect tension has been achi eved, move th machine backwards and forwards. 7. Check the track tens ion again, and if the tensio n is not correc adjust it again.