Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE WHEN REMOVING TRACK WARNING METHOD OF TIGHTENING MASTER LINK CONNECTING BOLT 686 ± 68.60 Nm (70 ± then check that the link 10 ° . 4 - 32 Depend ing on the situatio n, the operation to re move the t rack may be extremely dangerous Before removing the track, if the procedure "WH ENLOOSENING TENSION( PAGE 4 -31)" does not loosen the track tension, contact your K omatsu distributor f CHECK AND TIGHTEN TRACK SHOE BOL If the machine is used with track shoe bol ts being l oose , the y will break, so tighte n any l oose b olts immediatel METHOD OF TIGHTENING SHOE BOLT 1. Fir nu 2. Af 1.

Fir st tighten to a tig htening torque of 1 372 ± 13 7 Nm (14 0 ± 14 kgm, 1,012.6 ± 101. 3 lbft)) then check t hat the t and shoe are in close contact with the link c ontact su rface 2. Af ter checking, tigh ten a further 120° 1. Fir st tighten to a tig htening torque of ntact surfaces ar e in close contact. 2. Af ter checking, tigh ten a further 180° 7 kgm, 506.3 ± 5 0.6 lbf ORDER FOR TIGHTENING Tighte n the bolts in the order shown in the diagram on t he ri ght. CHECK ELECTRICAL INTAKE AIR HEATE (Starti ng aid Before starting the cold season (once a ye ar) pleas e contact your Komatsu distributo r to have the e lectrical heater for the engine checked for dirt or disconnections.