. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN RECOIL SPRING, ASSIST CYLINDER CASE, ADD OIL ambient CHECK FOR LOOSE ROPS MOUNT BOLTS If any loose bolt is found, the bolt with a genuine 4 - 67 Remove b olts (1), then re move cover (2). When rem in. Insert a sc ale and check t hat the oil level is 96 to 116 to 4.6 in) f If the oil le rom the bottom vel is low, add edge o engine f the insp oil so that Use Clas temperatu LUBRICATE TENSION PULLEY ASSEMBLY 1. Using a grease pump, apply grease to marked by the arrow. The grease fitting is filter on the left side of the machine. 2. After greasing, wipe off any old grease tha the grease fitting 1. 2. 1.
Using a grease pump, apply ting marked by the arrow . The greas e fitting is at the top o f the fuel filter on th e left side of the machine. t was pushed out. 2. After grea sing, wipe off a ny old grease tha t was pushed o ut. Check for loo se and damag ed bolt tighten to a to 1410 lbft). rque of 1520 to 1912 I f any damag Komatsu bolt. o 195 kgm, 112 1 to