Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE (If equipped) WARNING be 4 - 68 If the engine has been operated, all parts will be a t a high temperature, never try to replace the cartridge immediately aft er stoppi ng the engine Always wait for the en gine and other parts to coo Container to catc h drained coolant ench for fuel filter element. (1). o catch the coolant under the cartridge. nch, remove cartridge (2). Prepare a filter wr ench for fuel filter elem 1. Tighten 2 valves 2. Set a container t 3. Using a filter wre 4. Clean the filter h the new cartridg 5.

When installing, seal surface of t If the filter cartri damaged and th If the filter cartrid packing, so alwa 6. Open valves (1) 7. After replacing th coolant leakage leakage, check i 1. Tighten 2 valves 2. Set a container t o catch the coolant und er the c 3. Using a filter wre nch, remove cartridge ( 4. Clean the filter h older, coat the packing surface and t hread e with oil, then install it t o the fil ter holder. 5. When installing, tighten until the packing surfac e contacts t he filter holder, then tigh ten it u p 2/3 o f a tu dge is tightened too fa r, the p ackin is will lead to leakage o f coolan ge is too loose, coolant will also leak from t ys tighten to the correct amount.

(2 places). 7. After replacing th e cartridge, start the engine and check for a from the filter seal su rface. I f ther e is a f the cartridge is tighten ed properly. CHECK TIGHTENING PARTS OF TURBOCHARGER Contact your Komat su distributor to have th e tightening p ortion