. MAINTENANCE SERVICE PROCEDURE temperature. inside, replace it with a new hose. 4 - 73 CHECK PIVOT BEARING OIL LEVEL, ADD O 1. Remove plug (1). 2. Check that the oil is at the level shown in the d iagram. If the oil level is low, add en Use class CD SAE gine oil through the hole of 30 engine oil regardless plug (1 of the CLEAN ENGINE BREAT HER ELEMENT hen remove the hose. en remove breather (3). 1. 2. 3. 4. 1. 2. Loosen clamp (1), t Remove bolt (2), th hen remove the hos en remove breather Wash the whole br it dry with compres eather in diesel oil or flushing oil, then blow sed air. Replace the breath oil, and install it.
Check the breather er O-ring with a new part, coat with engine hose, and if there is any oil sludge on the CLEAN AND CHECK TU Contact your Komatsu distributor for cleani ng or i nspectio CHECK PLAY OF TURBOCHARGER ROTOR Contact your Komatsu distributor to have th e roto r play c hecked.