John Deere 450DLC, 650DLC, and 850DLC Excavators — Locking the Hydraulic Coupler to the Attachment

Operation—Operating the Machine Locking the Hydraulic Coupler to the Attachment CAUTION: Make sure hydraulic coupler is attached correctly to attachment. The supplemental lock can be engaged with the attachment in an incorrect lock position. A visual check is required each time the lock operation is performed. Failure to do so could result in serious injury or death. TX1017664A –UN–17JAN07 CAUTION: Attaching the bucket in a reverse orientation on the hydraulic coupler is not recommended. When installed in the reverse orientation, the bucket or the lift hook interferes with the arm of the excavator when the bucket is in full curl position by extending the bucket cylinder.

This is an inherent part of the design of the original equipment. TX1017662A –UN–17JAN07 Since the hydraulic coupler interacts with the arm at full curl position to unlock the supplemental lock, the hydraulic coupler will NOT operate properly when the bucket is attached in reverse orientation. NOTE: A safety buzzer will sound to alert personnel the lock/unlock function has been activated. 1. Engage front hook (1) on pin (2). Toggle switch on control box should be in UNLOCK position. TX1017663A –UN–17JAN07 NOTE: The hydraulic coupler must be held over relief in order to lock/unlock the hydraulic coupler cylinder. 2. Rotate to full-curl position. Move toggle switch to LOCK position.

Hold in full-curl position for 5 seconds. Bucket Rotated to Full-Curl Position 3. Slowly uncurl hydraulic coupler. Visually verify supplemental lock contacts locking plate. Visually verify lock plate is behind attachment pin. Toggle switch on the control box should be in the LOCK position. 1—Front Hook 2—Pin Continued on next page DW90712,0000450 –19–27JUN07–1/2 2-3-28 010609 PN=98