Operation—Operating the Machine NOTE: Do not operate attachment when the supplemental lock is used as the primary locking device. Doing so could result in hydraulic coupler failure. 4. Continue to slowly uncurl hydraulic coupler. Verify attachment is properly locked. Toggle switch on the control box should be in LOCK position. DW90712,0000450 –19–27JUN07–2/2 Unlocking the Hydraulic Coupler From the Attachment 1. Keep attachment close to ground. Toggle switch should be in LOCK position. TX1017663A –UN–17JAN07 NOTE: The hydraulic coupler must be held over relief in order to unlock the hydraulic coupler cylinder. 2. Rotate hydraulic coupler to full-curl position to release supplemental lock.
Toggle switch should be in LOCK position. Bucket Rotated to Full-Curl Position NOTE: A safety buzzer will sound to alert personnel the unlock function has been activated. 3. Move toggle switch to UNLOCK position. Hold in full-curl position for 5 seconds. 4. Slowly uncurl hydraulic coupler. Front hook (1) will release from pin (2). Toggle switch should be in UNLOCK position. TX1017662A –UN–17JAN07 1—Front Hook 2—Pin TX1017664A –UN–17JAN07 DW90712,0000451 –19–27JUN07–1/1 2-3-29 010609 PN=99