John Deere 450DLC, 650DLC, and 850DLC Excavators — Diesel Fuel

Maintenance—Machine Diesel Fuel Consult your local fuel distributor for properties of the diesel fuel available in your area. scar diameter of 0.45 mm as measured by ASTM D6079 or ISO 12156-1. In general, diesel fuels are blended to satisfy the low temperature requirements of the geographical area in which they are marketed. Sulfur content: Diesel fuel quality and fuel sulfur content must comply with all existing emissions regulations for the area in which the engine operates. Use of diesel fuel with sulfur content less than 0.10% (1000 ppm) is STRONGLY recommended. If diesel fuel with sulfur content greater than 0.2% (2000 ppm) is used, crankcase oil service intervals may be affected.

(See recommendation for Diesel Engine Oil.) Diesel fuels specified to EN 590 or ASTM D975 are recommended. Required fuel properties In all cases, the fuel shall meet the following properties: Cetane number of 45 minimum. Cetane number greater than 50 is preferred, especially for temperatures below -20 ° C (-4 ° F) or elevations above 1500 m (5000 ft). IMPORTANT: Do not mix used diesel engine oil or any other type of lubricating oil with diesel fuel. IMPORTANT: Improper fuel additive usage may cause damage on fuel injection equipment of diesel engines. Cold Filter Plugging Point (CFPP) below the expected low temperature OR Cloud Point at least 5 ° C (9 ° F) below the expected low temperature.

Fuel lubricity should pass a minimum level of 3100 grams as measured by ASTM D6078 or maximum VD76477,0000427 –19–13JAN06–1/1 3-1-1 010609 PN=100