John Deere 450DLC, 650DLC, and 850DLC Excavators — Periodic Maintenance Record Keeping System

Maintenance—Periodic Maintenance Periodic Maintenance Record Keeping System SERVICE INTERVALS Service your machine at intervals shown on this chart. Also, perform service on items at multiples of the original requirement. For example, at 500 hours also service those items (if applicable) listed under 250 hours, 100 hours, 50 hours, and 10 hours or daily.

As Required Drain fuel tank sump Drain water separator Clean fuel tank inlet screen Check primary air cleaner element Clean radiator inlet screen Check windshield washer fluid Inspect belt, adjust tension Check and adjust track sag Check air intake hose Add coolant extender as indicated by COOL-GARD II test strips Every 10 Hours or Daily Check radiator coolant level at tank Check hydraulic tank oil level Check engine oil level Grease working tool pivots and links Grease hydraulic coupler (450DLC only—if equipped) Every 50 Hours Grease front end pin joints OIL SAMPLING Oil samples should be taken from each system prior to its recommended drain/change interval indicated on this form:

500, 1000, 2000 hours. Maintenance recommendations supplied by OILSCAN will be provided based upon the oil analysis and operating information you supply. Regular oil sampling will extend the operational life of your machine’s systems.

Every 250 Hours Check battery electrolyte level and terminals Clean primary air cleaner element Check swing gearbox oil level Check pump drive gearbox oil level Check radiator coolant level Drain hydraulic tank sump Check travel gearbox oil level Take hydraulic tank oil sample Take engine oil sample * For applications with high sulfur fuel see operator’s manual for recommended engine oil drain intervals (Section 3-1) Every 500 Hours Grease swing bearing gear and replace gasket Clean cab recirculating air filter (replace every 6th cleaning) Drain and refill engine oil and replace filters Clean fresh air filter (replace every 6th cleaning) Replace fuel filter/water separator Grease swing bearing Check air intake hose Take engine coolant sample Replace pump case drain filter Take travel gearbox oil sample Take swing gearbox oil sample Take pump drive oil sample Take diesel fuel sample Every 1000 Hours Drain and refill swing gearbox oil Drain and refill pump drive gearbox oil (650DLC and 850DLC only) Clean engine crankcase vent tube and hose Replace pilot oil filter Replace hydraulic oil filter Replace hydraulic tank cap breather element Replace air cleaner elements Adjust engine valve lash Replace A/C V-Belt Check coolant Every 2000 Hours Drain and refill travel gearbox oil COOL-GARD is a trademark of Deere & Company Continued on next page DW90712,00000A0 –19–29DEC08–1/5 3-2-6 010609 PN=123