John Deere 450DLC, 650DLC, and 850DLC Excavators — Check Air Cleaner Elements — 850DLC

Maintenance—As Required Check Air Cleaner Elements 850DLC IMPORTANT: A missing, damaged, or hardened dust unloader valve will make the dust cup precleaner ineffective, causing very short element life. Valve should suck closed above 1/3 engine speed. TX1002246A –UN–05JAN06 Dust Unloader Valve Squeeze dust valves (1) to remove dust from the air cleaner. If operating in high dust conditions, squeeze dust valves every couple of hours of operation to release dust. 1—Dust Unloader Valve DW90712,0000041 –19–31OCT06–1/3 Primary Element 1. Unlock clamps (2), and pull air cleaner cover outward to remove. 2. Pull primary element (3) straight out to remove. TX1002271A –UN–05JAN06 3.

Tap primary element with the palm of your hand, NOT ON A HARD SURFACE. CAUTION: Prevent possible injury from flying chips if compressed air is more than 210 kPa (2.1 bar) (30 psi). Reduce compressed air to less than 210 kPa (2.1 bar) (30 psi) when using for cleaning purposes. Clear area of bystanders, guard against flying chips, and wear personal protection equipment including eye protection. TX1002272A –UN–05JAN06 4. If this does not remove dust, use compressed air under 210 kPa (2.1 bar) (30 psi). Specification Compressed Air—Pressure Under 210 kPa (2.1 bar) (30 psi) ................... 5. Direct air up and down from inside to outside. Be careful not to make a break in the element.

2—Clamps (3 used on each Air Cleaner) 3—Primary Element Continued on next page DW90712,0000041 –19–31OCT06–2/3 3-3-3 010609 PN=130