John Deere 450DLC, 650DLC, and 850DLC Excavators — Drain Water Separator

Maintenance—As Required Check and Adjust A/C V-Belt Visually check the belt for wear. Replace if necessary. NOTE: When a new belt is installed, be sure to readjust the tension after operating the engine for 3 to 5 minutes at slow idle speed to be sure that the new belt is seated correctly. TX1002128A –UN–03JAN06 Use the following steps to adjust compressor belt tension: 1. Check compressor belt tension by depressing the midpoint between compressor pulley (1) and crank pulley (2) with thumb. 1—Compressor Pulley 2—Crank Pulley 3—Cap Screw 4—Tension Pulley 5—Cap Screw Specification Compressor Belt—Deflection 9 mm to 12 mm ........................................... 0.35 in. to 0.47 in.

—Depressing Force 98 N ............................................................................ 10 kgf 22 lbf 2. If tension is not within specifications, loosen cap screw (3). 3. Move the tension pulley (4) by cap screw (5) until tension is correct. Tighten cap screw (3). DW90712,000037C –19–31OCT06–1/1 Drain Water Separator 1. Open front engine cover to access water separator. 2. Loosen plug (1) on the top of the water separator. TX1002093A –UN–03JAN06 3. Open drain valve (2) to extract water or debris from fuel system. Collect waste in a container, and dispose of it properly. 4. Close drain valve. 5. Tighten plug. 650DLC Shown 6. Bleed fuel system.

(See Bleed Fuel System in this Section.) 1—Plug 2—Drain Valve DW90712,000001B –19–20JAN06–1/1 3-3-7 010609 PN=134