John Deere 450DLC, 650DLC, and 850DLC Excavators — Bleed Fuel System

Maintenance—As Required Bleed Fuel System IMPORTANT: Over tightening the air bleed plugs can cause damage. NOTE: Fuel filter air bleeding should be done one side at a time. Start with air bleed plug (1) and when finished, repeat procedure for air bleed plug (2). TX1002075A –UN–03JAN06 1. Turn the manual prime pump knob (3) counterclockwise until plunger pops up. 2. Loosen the fuel filter air bleed plug (1). 650DLC Shown 3. Move the priming pump until air bubbles stop coming out. 4. Tighten bleed plug (1). TX1002076A –UN–03JAN06 5. Loosen the fuel filter air bleed plug (2). 6. Move the priming pump until air bubbles stop coming out. 7. Tighten bleed plug (2). 8.

After tightening all of the plugs, move the priming pump until it becomes heavy. 1—Bleed Plug 2—Bleed Plug 3—Manual Priming Pump Knob The priming pump needs to be moved a total of more than 150 times. 9. Tighten the manual priming pump knob to its previous position, and start the engine. If the engine doesn’t start, repeat once again from step 5. DW90712,000001A –19–03JAN06–1/1 3-3-8 010609 PN=135