John Deere 450DLC, 650DLC, and 850DLC Excavators — Check Windshield Washer Fluid Level

Maintenance—As Required IMPORTANT: Prevent possible damage to track components. DO NOT use the grease fitting on the track adjusting cylinder for lubrication. Use this fitting ONLY for track adjustment. 1. To tighten track, connect a grease gun to grease fitting (1) (located through access hole (4) in track frame). Add grease until sag is within recommended limits. T135187 –UN–06NOV00 CAUTION: Prevent possible injury from high pressure grease. DO NOT remove grease fitting (1) from nut (2). 2. To loosen, slowly turn nut (2) counterclockwise; grease will escape through the bleed hole (3). 3. When amount of track sag is satisfactory, turn nut clockwise to tighten.

T135188 –UN–06NOV00 Specification Nut—Torque 147 (108 lb-ft) ................................................................ 1—Grease Fitting 2—Nut 3—Bleed Hole 4—Access Hole DW90712,0000042 –19–23OCT08–3/3 Check Windshield Washer Fluid Level Open left front access door. Check fluid in windshield washer tank (1). If necessary, remove fill cap to add fluid. During winter season, use all season windshield washer fluid which will not freeze. T140231 –UN–21MAR01 1—Windshield Washer Tank DW90712,0000010 –19–21DEC05–1/1 3-3-10 010609 PN=137