John Deere 450DLC, 650DLC, and 850DLC Excavators — Replace Fuel Filters

Maintenance—Every 500 Hours 11. Remove filler cap (3). Specification 450DLC—Oil Capacity With Filter Change 55.8 L ............................................................................................. 14.75 gal 650DLC—Oil Capacity With Filter Change 57.0 L ............................................................................................. 15.1 gal 850DLC—Oil Capacity With Filter Change 57.0 L ............................................................................................. 15.1 gal TX1002118A –UN–03JAN06 12. Add oil to specifications. 3—Filler Cap 4—Dipstick 13. Install filler cap. 14. Start engine. Engine oil pressure indicator must go out within 15-20 seconds.

If not, stop engine immediately, and find the cause. 15. Stop engine. Check oil level on dipstick (4). Check for any leakage at filter. Tighten filter just enough to stop leakage. DW90712,000001C –19–31OCT06–2/2 Replace Fuel Filters 1. Turn canisters (1) counterclockwise to remove filters. Dispose of filters properly. Allow sediment to drain into a container. Dispose of waste properly. TX1002140A –UN–04JAN06 2. Clean mounting surface on filter bases. 3. Clean sediment canisters. 4. Install O-rings. Install new filters. Install canisters. 5. Bleed fuel system. (See Bleed Fuel System in Section 3-3.) 650DLC Shown 1—Fuel Filters DW90712,000001D –19–10JAN06–1/1 3-7-3 010609 PN=158