John Deere 450DLC, 650DLC, and 850DLC Excavators — Replace Engine A/C V-Belt

Maintenance—Every 1000 Hours 3. Remove rubber pressure release button. 4. Remove cap screw under the pressure release button, and then remove hydraulic tank cap breather element cover (2) by turning counterclockwise. 5. Remove hydraulic tank cap breather element (3). Install new element. IMPORTANT: Do not allow water and/or contaminants to stay between cover (2) and body (4). 6. Install element cover until it comes in contact with the breather element. Then, further tighten the cover 1/4 turn. TX1001448 –UN–16DEC05 7. Install cap screw, and securely install rubber pressure release button.

1—Pressure Release Button 2—Hydraulic Tank Cap Breather Element Cover 3—Hydraulic Tank Cap Breather Element 4—Body DW90712,000004A –19–23JAN06–2/2 Replace Engine A/C V-Belt NOTE: When a new belt is installed, be sure to readjust the tension after operating the engine for 3 to 5 minutes at slow idle speed to be sure that the new belt is seated correctly. TX1002128A –UN–03JAN06 1. Loosen the tension pulley (4) by unscrewing cap screw (3). 2. Remove and discard belt. 3. Install new A/C belt. 4. Tighten cap screw (3) to specification.

1—Compressor Pulley 2—Crank Pulley 3—Cap Screw 4—Tension Pulley 5—Cap Screw Specification Compressor Belt—Deflection 9 mm to 12 mm ........................................... 0.35 in. to 0.47 in. —Depressing Force 98 N ............................................................................ 10 kgf 22 lbf DW90712,000037D –19–31OCT06–1/1 3-8-8 010609 PN=173