Miscellaneous—Machine Welding On Machine IMPORTANT: Disconnect battery ground strap or turn battery disconnect switch to "OFF" to prevent voltage spikes through alternator or monitor. Separate harness connectors to engine and vehicle microprocessors. Connect welder ground clamp close to each weld area so electrical current does not arc inside any bearings. Disable electrical power before welding. Turn off main battery switch or disconnect positive battery cable. TX,90,DH5140 –19–03JAN07–1/1 Clean the Machine Regularly Remove any grease, oil, fuel, or debris build-up to avoid possible injury or machine damage. IMPORTANT:
Directing pressurized water at electronic/electrical components or connectors, bearings and hydraulic seals, fuel injection pumps or other sensitive parts and components may cause product malfunctions. Reduce pressure and spray at a 45 to 90 degree angle. T6642EJ –UN–18OCT88 High pressure washing (greater than 1379 kPa (13.8 bar) (20 psi) can damage freshly painted finishes. Paint should be allowed to air dry for 30 days minimum after receipt of machine before cleaning with high pressure. Use low pressure wash operations until 30 days have elapsed. Do not spray oil cooler fins at an angle. Fins may bend. TX03679,00017E0 –19–28JUN06–1/1 4-1-7 010609 PN=189