John Deere 450DLC, 650DLC, and 850DLC Excavators — Removing the Bucket

Miscellaneous—Machine Replacing Bucket Tooth Tip—Heavy-Duty Bucket 1. Clean tooth (A) and tooth tip (B). 2. Insert lock removal tool under U-shaped pin (C). T6879EE –UN–06DEC88 CAUTION: Avoid possible injury. Pin may fly after it is released from tooth tip. Keep a firm grip on pin to prevent injury. 3. Remove pin. 4. Turn tooth tip counterclockwise and pull it towards you to remove. 5. Clean tooth shank. 6. Replace U-shaped pin at same time you replace tooth tip. T7527DO –UN–27JUN91 7. Insert tooth tip on shank turning tip clockwise. 8. Install U-shaped pin. Side of pin marked "FRONT" (D) must face tooth tip. Make sure pin is firmly engaged over tooth tip.

A—Tooth B—Tooth Tip C—Pin D—"Front" Mark 04T,90,K273 –19–03JAN07–1/1 Removing the Bucket 1. Lower bucket to the ground. 2. Remove snap rings and locking pins. 3. Slide O-ring seals out of way. Remove bucket pins. 4. Install and adjust bucket. See Adjust Bucket To Arm Joint in this section. 04T,90,M35 –19–24JAN07–1/1 4-1-15 010609 PN=197