Miscellaneous—Machine Track Sag General Information To maximize undercarriage life, keep track sag within specification. Tracks may require adjustment several times during a working day due to changing soil type and moisture content. operation will result in excessive pin and bushing wear, sprocket popping, tooth tip wear, and excessive loads on the entire undercarriage and travel drive system. Machine productivity and fuel consumption are also adversely affected because increased horsepower is needed to move the machine. Adjust tracks in the actual operating conditions. TIGHT TRACK: Packing causes a tight track.
If material packs in the undercarriage, adjust tracks with the material packed in the components. LOOSE TRACK: A loose track has more side to side motion, increasing side wear on the links, rollers, and front idler. An excessively loose track will slap at high ground speeds, resulting in high impact loads on the sprocket teeth, bushings, and carrier rollers. While the track spring will recoil and the machine can continue to operate with a tight track, continued VD76477,00001F7 –19–30JAN06–1/1 Check Track Shoe Hardware Tracks shoes should be checked periodically for loose or missing cap screws and nuts.
For shoes with missing or loose cap screws and nuts, remove shoes and clean the mating surface of shoes and links before tightening cap screws and nuts. The cap screws should be replaced because they have been stretched to yield previously. T6352AH –UN–23FEB89 Operating a machine with loose shoes can cause the cap screws and holes in the shoes and links to wear making it difficult to keep the shoes tight. Loose shoes can also cause hardware failure and loss of shoes. 1. Clean the mating surface of shoe and links. Install shoes. 2. Apply a light coating of oil to cap screw threads before installing. 3.
Install nuts with the rounded corners against milled surface of link and chamfered side is away from link. Check that nuts are square with the milled surface of link and there is full contact between nut and milled surface. As necessary, hold the nut so it does not turn. 4. Starting at any cap screw, tighten all cap screws in sequence shown to specification. TX14740,0001CFC –19–20MAY08–1/1 4-1-16 010609 PN=198