Miscellaneous—Transporting—450DLC Retracting the Side Frame IMPORTANT: Remove debris from contact areas of track frame (C) and side frame (D) or mounting cap screws may be loosened. Required Tools: T122587 –UN–05AUG99 Power Boost Wrench (including accessories) Torque width (width across flats: 50 mm) Air Compressor (slide surface cleaning) CAUTION: Do not loosen the mounting cap screws (B) of guide on the side frame. 1. Remove eighteen mounting cap screws (A) (9 used for each side) from the retracting side frames. IMPORTANT: Maintain a 90 to 110 ° angle between the boom and the arm. T122588 –UN–05AUG99 Do not raise the track too high or operate the arm control lever abruptly.
Damage to the track frame may result. 2. Retracting Side Frame (Track Gauge)—Turn the boom mode switch OFF so that the machine can be raised off the ground with front attachment. A—Mounting Cap Screws (18 used) B—Guide C—Track Frame D—Side Frame 3. Raise the side track using the front attachments, as illustrated. Slowly rotate the raised track back and forth. The side frame will be retracted with its own weight and stop when it comes into contact with guide (B). If parts of the side frame do not retract lower the undercarriage and turn the upperstructure 180 ° . Raise the opposite side track about 15 ° from the ground using the front attachment.
Slowly push the arm out to retract the side frame. Continued on next page DW90712,0000072 –19–18JAN07–1/2 4-2-10 010609 PN=210