John Deere 450DLC, 650DLC, and 850DLC Excavators — Extending the Side Frame

Miscellaneous—Transporting—450DLC 4. Slowly lower the track to the ground. Tighten six mounting cap screws (A) (3 used for each side) to specification. Specification 450DLC Side Frame Mounting Cap Screw—Torque 1750 ................................................................... 1290 lb-ft T122589 –UN–05AUG99 5. Retract the opposite side, following steps 1 to 4 above. A—Mounting Cap Screw (6 used) DW90712,0000072 –19–18JAN07–2/2 Extending the Side Frame Necessary Equipment 3. Power Boost Wrench (including accessories), width across flats of the torque wrench: 50 mm 4. Air Compressor (slide surface cleaning) 5. Soft Protectors 1. Slinging Rope (20 mm dia.

x 8 m, 6 x 37 Ordinary Z lay Class A, Applicable Max. Load: 3 tons) (4 Used). Before Slinging, make sure no broken wire strands and/or kinks exist. 2. Lever Block (JIS B8819 equivalent to L3.2T) (2 Used). Check that there is no damage on the lever block. Continued on next page DW90712,0000073 –19–18JAN07–1/5 4-2-11 010609 PN=211