Miscellaneous—Transporting—650DLC 1. Before starting work, coordinate work procedures with co-workers. 2. When extending the side frame using the front attachment, do not allow any personnel to enter the vicinity of the machine. T122560 –UN–05AUG99 CAUTION: Do not loosen side frame guide cap screws (D). IMPORTANT: When the machine is shipped from the factory, not all side frame tightening cap screws are installed. Therefore, unbolted screw holes on the side frame are coated with rust-inhibitor and they may be clogged with dust or soil. Before installing the cap screws, clean the thread surface thoroughly. If the cap screws are difficult to tighten, tap the screw holes again.
A—Mounting Cap Screw B—Track Frame C—Side Frame D—Guide Cap Screw Tap: M 33, Pitch: 3 mm Clean the side frame slide surfaces using compressed air. If debris is stuck on the contact areas of track frame (B) and side frame (C), loose mounting cap screws (A) may result. T122561 –UN–05AUG99 1. Remove side frame mounting cap screws (A) (6 used, 3 cap screws in two places) from the extending side frame. 2. Rotate the upperstructure to the side of the extending side frame until the front attachment faces the side frame perpendicularly. 3. Position the arm and boom angle between 90 ° and 110 ° . Lower the bucket bottom to the ground.
Continued on next page AM40430,0000305 –19–18JAN07–2/5 4-3-11 010609 PN=226