John Deere 450DLC, 650DLC, and 850DLC Excavators — Extending the Side Frame

Miscellaneous—Transporting—650DLC 4. Wind two cables or chains (B) around the front and rear sections (one cable or chain on each section) of the side frame. Connect lever block (C) to the ends of each cable or chain. Attach soft protectors (D) between the side frame (A) corners and cables or chains to prevent damage to side frame and cables or chains. T122562 –UN–05AUG99 5. Wind two cables or chains (F) around the arm near the bracket of bucket (E). Connect each cable or chain end to lever blocks. Slowly extend the front attachment to remove sag on cables or chains. Attach soft protectors (D) between the bucket bracket corners and cable or chain to prevent damage to cables or chains. 6.

While lowering the boom, raise the extending side frame approx. 50 mm (2 in.) above the ground. If the side frame is raised too much, extending force increases. CAUTION: When the lever block becomes inoperable, it is because too much resistance exists against the extending force. T122563 –UN–05AUG99 Stop the work and check if the front and rear of the side frame are equally extended or if the side frame is raised to the proper height. Take corrective measures as necessary. 7. Operate lever blocks so that the rear (travel device side) and front (front idler side) of the side frame is equally extended until side frame guide comes in contact with the track frame stopper.

T122564 –UN–05AUG99 A—Side Frame B—Cable Or Chain C—Lever Block D—Soft Protector E—Bucket F—Cable Or Chain Continued on next page AM40430,0000305 –19–18JAN07–3/5 4-3-12 010609 PN=227