Miscellaneous—Transporting—850DLC Loading/Unloading CAUTION: Always turn the auto-idle switch OFF when loading or unloading the machine to avoid an unexpected speed increase due to unintentional operation of a control lever. T122571 –UN–05AUG99 Move travel speed switch to slow speed mode. Do Not steer while driving up or down a ramp. If repositioning is necessary, move back to the ground or flatbed, correct travel direction, and drive again. Loading: 1. The machine direction should be as follows: Without the front attachment: Travel in reverse. 2. The centerline of the machine should be over the centerline of the trailer. 3. Drive the machine onto the ramp slowly. 4. Stop the engine.
Remove key from switch. 5. Move the control levers several times until hydraulic pressure in the lines is released. 6. Pull pilot control shutoff lever to locked position. 7. Close cab windows, roof vent, and door, and cover the exhaust opening, to prevent entry of wind and water. IMPORTANT: Fasten chains or cables to the machine frame or track chain links. Do not place chains or cables over or against the hydraulic lines or hoses. 8. Place blocks in front of and behind the tracks. Unloading: Move the machine over end of the trailer onto the ramp slowly. AM40430,0000306 –19–31OCT06–2/2 4-4-2 010609 PN=231