John Deere 450DLC, 650DLC, and 850DLC Excavators — Extending the Side Frame

Miscellaneous—Machine Assembly Installing Bucket 1. Install the O-rings around the bucket bosses at the arm connecting section. 2. Start the engine. Raise the arm tip approximately 2.5 m (2.7 yd) above the ground. T122558 –UN–05AUG99 3. Lift bucket (D) with a crane. Align pin (C) with pin hole (B) of the arm. CAUTION: When aligning the centers of the pin and pin hole, Do Not put fingers into the pin hole. When using a hammer, wear safety equipment to protect against injury from flying pieces of metal. While installing the bucket pin, Do Not allow anyone to enter the area under the bucket. T122559 –UN–05AUG99 4. Install pin into the pin bosses. Secure pin with cap screw (F) and nuts (G). 5.

While extending or retracting the bucket cylinder, align pin hole (A) of the link with that of bucket (D). A—Pin Hole B—Pin Hole C—Pin D—Bucket E—Cap Screw F—Cap Screw G—Nut H—Nut 6. Install the pin into the bucket and link. Secure the pin with cap screw (E) and nuts (H). Install double nuts and tighten. Specification Pin in Bucket and Link Cap Screws—Torque 400 ........................................................................... 290 lb-ft DW90712,000007B –19–08FEB06–1/1 Retracting the Side Frame See Retracting the Side Frame. (Section 4-2.) DW90712,000007D –19–08FEB06–1/1 Extending the Side Frame See Extending the Side Frame.

(Section 4-2.) DW90712,000007F –19–08FEB06–1/1 4-5-16 010609 PN=259