Operation—Operating the Machine 13. Open left rear access door and pull off lever cover (A) of counterweight pilot control valve (B). 14. Start engine. Run machine at slow idle. 15. Leave pilot shutoff lever in locked (UP) position. T107391 –UN–06MAR97 CAUTION: To ensure good footing and visibility always stand on the machine service walk when operating counterweight pilot control valve. 16. Slowly move counterweight pilot control valve lever UP and DOWN several times to check response of cylinder control. A—Cover B—Control Valve DW90712,00001F0 –19–12SEP08–8/12 17. Remove both lock pins from slotted nuts (B) on counterweight tie bolts (A). 18.
Alternately loosen each counterweight tie bolt two or three turns. 19. Using a standard screwdriver, pry corner of lock plate (G) away from head of each of the lower counterweight boss cap screws (F). 20. Loosen each cap screw 5 mm (0.20 in.) A—Tie Bolt (2 used) B—Slotted Nut (2 used) C—Boss Plate (2 used) D—Counterweight E—Shim (as required) F—Cap Screws (4 used) G—Lock Plate (2 used) T8172AD –UN–20FEB94 Continued on next page DW90712,00001F0 –19–12SEP08–9/12 2-3-19 010609 PN=89