Operation—Operating the Machine 10. Loosen jam nuts and adjusting cap screws (1) to loosen lifting yokes (4) from counterweight pin brackets. 11. Slide the lifting yokes forward to the upward position of slot (3) away from the rear of counterweight (5). 1—Adjusting Nut (2 used) 2—Yoke-To-Counterweight Pin (2 used) 3—Slot 4—Yoke (2 used) 5—Counterweight TX1011165 –UN–16AUG06 DW90712,00001F0 –19–12SEP08–6/12 IMPORTANT: To ensure full thread engagement of cap screw (B) in yoke (D), length (A) must not exceed 110 mm (4.33 in.) 12. Tighten adjusting cap screws (B) enough to hold both lifting yokes in the forward position. Tighten jam nuts (C).
A—105 mm (4.13 in.) Approximate B—Adjusting Cap Screw (2 used) C—Nut (2 used) D—Yoke (2 used) E—Yoke-To-Counterweight Pin (2 used) F—Washer (2 used) G—Lock Pin (2 used) H—Flat Washer (2 used) T8174AL –UN–23SEP94 Continued on next page DW90712,00001F0 –19–12SEP08–7/12 2-3-18 010609 PN=88