John Deere 450DLC, 650DLC, and 850DLC Excavators — Counterweight Removal

Operation—Operating the Machine CAUTION: When threads of counterweight-to-mainframe tie bolt (A) disengage from slotted nut (B), the slotted nut and slotted nut spacer may drop to the ground. Stay clear from under machine when removing tie bolts. CAUTION: Clear everyone from the area before removing or installing the counterweight. Specification 450DLC Counterweight— Approximate Weight 9150 kg (20,172 lb) .................................................... Specification 650DLC Counterweight— Approximate Weight 11,000 kg (24,471 lb) .................................................

Specification 850DLC Counterweight— Approximate Weight 13,300 kg (29,321 lb) ................................................. T8172AD –UN–20FEB94 22. To avoid binding, remove large counterweight-to-mainframe tie bolts (A) by alternately turning each bolt one turn at a time. NOTE: To avoid binding, alternately loosen left hand and right hand counterweight boss cap screws two or three turns at a time. A—Tie Bolt (2 used) B—Slotted Nut (2 used) C—Boss Plate (2 used) D—Counterweight E—Shim (as required) F—Cap Screw (4 used) G—Lock Strap (2 used) 23. Remove cap screws (F), plates (G), spacers and shims (E) from each counterweight boss. 24.

Slowly lower counterweight to the ground until all weight is removed from linkage and yokes move freely in their slots. 25. Remove counterweight yoke-to-link pins. 26. Raise counterweight cylinder to end of its stroke. 27. Store yoke-to-link pins by attaching pins to counterweight lift brackets. 28. Close hydraulic counterweight shutoff valve by turning valve handle clockwise and tighten jam nut. Continued on next page DW90712,00001F0 –19–12SEP08–11/12 2-3-21 010609 PN=91