Operation—Operating the Machine NOTE: Replace lock plate if damaged. 16. Install shims (E), plates (C), lock plates (G), and cap screws (F) to counterweight bosses. Tighten cap screws (F) to specification. Specification Plate And Lock Plate Cap Screw—450DLC—Torque 450 ............................................................ 325 lb-ft Plate And Lock Plate Cap Screw—650DLC—Torque 700 ............................................................ 510 lb-ft Plate And Lock Plate Cap Screw—850DLC—Torque 700 ............................................................ 510 lb-ft 17. Bend one top and one bottom corner of lock plates (G) against heads of cap screws (F). 18.
Tighten counterweight-to-frame tie bolts (A). T8172AD –UN–20FEB94 Counterweight—Specification 450DLC Counterweight-To-Frame Tie Bolt—Torque 2400 (1735 lb ft) ..................................................... Counterweight—Specification 650DLC Counterweight-To-Frame Tie Bolt—Torque 2800 (2065 lb ft) ..................................................... Counterweight Hardware Counterweight—Specification 850DLC Counterweight-To-Frame Tie Bolt—Torque 2800 (2065 lb ft) ..................................................... A—Counterweight-To-Frame Cap Screw B—Nut C—Plate D—Counterweight E—Shim F—Cap Screw G—Lock Plate 19.
Tighten or loosen cap screws (A) if necessary to install quick lock pins to nut (B). IMPORTANT: Lower counterweight cylinder slightly to slide yokes (J) to back of slots (K). Lift arms must be below top surface of counterweight to prevent interference with counterweight top cover. 20. Close shutoff valve and tighten jam nut. Continued on next page MD04263,0000095 –19–09DEC08–6/7 2-3-26 010609 PN=96