Adjust Track Sag Track System NOTE: Check sag after a short period of operation when changing from one ground condition to another or when operating in extreme soil packing conditions. 01 0130 52 Specification Lubricated Track Chain—Track Sag 51 ± 6 mm (2 ± 1/4 in.) ........................................................................ T6044CJ –UN–23FEB89 1. Allow machine to slowly roll to a stop in the forward direction. For the most accurate measurement, a link pin must be centered on carrier roller. 2. Measure track sag between carrier roller and front idler at the lowest point. (See "Track Sag" decal on machine. Decal located next to right engine compartment access door.) IMPORTANT:
Grease fitting on track adjuster head is used for track sag adjustment only. Fitting on cylinder barrel adjuster housing is used to fill cavity between cylinder barrel and adjuster housing to keep water out. Piston must move using a 22 500 kPa (550 bar) (8000 psi) maximum capacity grease gun or seals may be damaged. If piston does not move, check for seized track adjuster parts. (See Disassemble and Assemble Track Adjuster Cylinder in this group.) 3. To decrease sag, apply grease to fitting (A) using a 55 200 kPa (550 bar) (8000 psi) maximum capacity grease gun. After adding grease, operate machine to allow track adjuster cylinder to fully adjust and then check sag again.
Each time track is adjusted apply grease to grease fittings on cylinder barrel adjuster housing until grease escapes past wiper seal. TM1859 (14JUL04) 01-0130-52 700H Crawler Dozer Continued on next page CED,TX03399,5955 –19–24MAR00–1/2 071404 PN=102