Track System 2. If lower wear plate (7) or shims (8) are required. Remove front idler. (See Remove and Install Front Idler in this group). 01 0130 NOTE: If operating conditions require roller to be raised shims maybe added to lower wear bar to raise roller. 60 4. Install front idler if removed. (See Remove and Install Front Idler in this group). 5. Loosen jam nut (2) and cap screw (1). 6. Tighten cap screws (1) until bottom out. T132047B –UN–28JUN00 7. Loosen cap screws (1) equally one turn to obtain clearance at (4). Specification Wear plate vertical clearance.— Clearance 2 mm (0.079 in.) maximum ........................................................
1—Cap Screw (8 used) 2—Jamb Nut (8 used) 3—Shim 4—Vertical Clearance 5—Horizontal Clearance 6—Upper Wear Plate (2 used) 7—Lower Wear Plate (2 used) 8—Shim 9—Cap Screw (4 used) 8. Tighten jam nuts. 9. Add shims equally to each side at (3) to obtain horizontal clearance (5). Specification Wear plate horizontal clearance.—Clearance 2 mm (0.079 in.) maximum .................................... 10. Install track chain. (See Remove and Install Lubricated Track Chain in this group). CED,TX03399,5959 –19–24MAR00–2/2 TM1859 (14JUL04) 01-0130-60 700H Crawler Dozer 071404 PN=110