Track System TM1859 (14JUL04) 01-0130-61 700H Crawler Dozer 071404 PN=111 Check Front Idler Oil Level Removing the idler oil level plug (1) does not always indicate oil level. Possible vacuum in the oil cavity can keep oil from flowing out. Idlers that appear low or out of oil may have sufficient oil. Applying a small amount of low –UN–28JUN00 volume forced air into the idler will overcome the vacuum and allow a small amount of oil to flow from idler. NOTE: The oil fill hole should be on outside of idler on T132080B the right side of machine. The oil fill hole should be on the inside of idler on the left hand side of the machine. 1—Oil Level Plug 1. Rotate plug opening (1) to a 45° angle. 2.
Remove the oil level fill plug (1). If oil flows out, oil level is correct. If oil does not flow, insert the nozzle of a plastic bottle into the hole and squeeze air pressure into idler. A slight amount of pressure inside the idler will relieve any vacuum and allow oil to flow from fill hole. 3. Add proper oil slowly using oil can. 4. Add oil until oil flows from oil level hole. 5. Apply pipe sealant or TEFLON tape to new plug. Install and tighten oil level plug. Front Idler—Specification Oil Level Plug—Torque.......................................41 ± 4 N•m (30 ± 3 lb-ft) TEFLON is a registered trademark of Du Pont Co. CED,TX03399,5960 –19–24MAR00–1/1 01 0130 61