Track System TM1859 (14JUL04) 01-0130-63 700H Crawler Dozer 071404 PN=113 Remove and Install Track Idler Recoil Spring IMPORTANT: When sliding idler assemble forward, do not pull track adjusting piston from yoke as scraper seal may damage piston seal. –UN–01JUN89 1. Remove and slide front idler with hydraulic track tension adjuster assembly forward. (See Remove and Install Front Idler in this group.) T6555DH 2. Remove cover. CAUTION: Always use the special bolt to prevent accidental release of idler recoil spring. 3. Thoroughly clean threads on JD314-2B or JD314-2C screw and in spring adapter.
Apply John Deere NEVER-SEEZ to threads and contact area between cap screw head, washer and positioning guide. 4. Install JD314B Track Spring Compressor Kit (as shown in photo) through track adjuster housing and thread into spring adapter. CAUTION: Spring or rod may break if dropped while handling, transporting or disassembling. Nicks or weld craters in spring and rod assembly can cause stress concentration resulting in a weak spot that may result in immediate or eventual failure creating a risk of personal injury. Put a heavy protective covering around spring assembly when handling, transporting or disassembling.
A compression tool must be used for disassembly and assembly because of the extreme preload on spring. 5. Remove spring retainer plate cap screws and remove spring. 6. Release compression on track spring immediately after removal.(See Disassemble and Assemble Track Idler Recoil Spring in this group.) NEVER-SEEZ is a registered trademark of Emhart Chemical Group Continued on next page CED,TX03399,6112 –19–16JUN00–1/2 01 0130 63