John Deere 700H Crawler Dozer — Remove and Install

Removal and Installation 33. Remove hydraulic lines and fittings from pumps. Tag lines and mark orientation of fittings to aid in reassembly. T118254B –UN–17NOV98 TM1859 (14JUL04) 03-0300-11 700H Crawler Dozer Continued on next page CED,TX03399,5973 –19–24MAR00–9/15 071404 PN=155 26. Drill and tap two 1-1/16 plugs to accommodate a 1/2 in. eye bolt. 27. Install eyebolts as shown. 28. Connect hydrostatic pumps to hoist using chains and –UN–10DEC98 DF1063 Final Drive and Pump Lifting Bracket. (See Group 099 for instructions to make tool.) 29. Attach DFT1130 Adapter to DF1063. (See Group T118456A 0399 for instructions to make tools.) 30. Remove cap screws (7). CAUTION:

The approximate weight of the hydrostatic pump assembly is 120 kg (265 lb). Hydrostatic Pump—Specification Dual Hydrostatic Pump Assembly—Weight..................................... 120 kg (265 lb) (Approximate) 31. Remove flywheel housing cover cap screws and pull pumps back far enough for dampener hub to clear flywheel dampener. Place a wood block under rear pump and lower pumps to rest on frame. Disconnect rear chain, shorten and reconnect to lift pumps out at approximate 30 degree angle. 32. Carefully remove pumps from left side of machine, flywheel housing plate first. The best clearance is achieved close to the floor, passing through the recess in console frame.

CED,TX03399,5973 –19–24MAR00–8/15 03 0300 11