Hydrostatic System IMPORTANT: New journal bearing MUST be sized using a JDG1072 Journal Bearing Sizing Tool. DO NOT use the pump shaft. This will cause inadequate lubrication and shortened bearing life. 19. Size the journal bearing using a JDG1072 Journal Bearing Sizing Tool (C). C—Journal Bearing Sizing Tool RW25782 –UN–21JUN97 03 0360 10 CED,OUTX547,110 –19–28JUN02–6/22 NOTE: Shims for springs (1) may stay with the end cap during end cap removal. 20. Remove and inspect springs (1 and 4) and shims. Swashplate—Specification Swashplate Leveling Outer Springs—Free Length 88.2 mm (3.5 in.) (Approximate) ............................. Test Length 83.3 mm at 160 N (3.3 in.
at 36 lb force) .............................................. T156798B –UN–27JUN02 Swashplate Leveling Inner Springs—Free Length 81 mm (3.2 in.) (Approximate) ................................ Test Length 76.2 mm at 78 N (3.0 in. at 17.5 lb force) ............................................. Swashplate Hold-Down Spring— Free Length 21.6 mm (0.85 in.) (Approximate) ........................................... Test Length 19.8 mm at 613 N (0.78 in. at 138 lb force) ................................................. 1—Spring (2 used) 2—Alignment Pin (2 used) 3—Valve Plate 4—Hold Down Spring IMPORTANT: Note the direction of arrows stamped on valve plate and mark housing accordingly. 21.
Remove valve plate (3). 22. Remove alignment pins (2). TM1859 (14JUL04) 03-0360-10 700H Crawler Dozer Continued on next page CED,OUTX547,110 –19–28JUN02–7/22 071404 PN=200