John Deere 700H Crawler Dozer — Disassemble

Hydrostatic System IMPORTANT: Do not damage the end cap surface when removing or installing bearing (A). 16. Inspect journal bearing (A). 17. Carefully remove the bearing using D01061AA Blind-Hole Puller (B). T118279 –UN–17NOV98 18. Lightly lubricate the new journal bearing and install into end cap using a press. Hydrostatic Pump—Specification End Cap Journal Bearing—Depth Flush-to-0.50 mm (0.020 in.) ................ A—Journal Bearing B—Blind Hole Puller Continued on next page CED,OUTX547,110 –19–28JUN02–5/22 TM1859 (14JUL04) 03-0360-9 700H Crawler Dozer 071404 PN=199 14. Remove the two small socket head cap screws (3 and 4) and socket head cap screws with washers (2). NOTE:

Leveler spring shims may dislodge during end cap removal. 15. Remove adapter plate and O-ring from end cap. –UN–15JAN99 Remove end cap and gasket from pump housing. 1—Adapter Plate 2—Socket Head Cap Screw with Washer (4 used) T119614B 3—Socket Head Cap Screw with Lift Bracket 4—Socket Head Cap Screw CED,OUTX547,110 –19–28JUN02–4/22 03 0360 9