Hydrostatic System 35. Place cylinder block on a clean non-abrasive surface to replace speed ring. Be careful not to damage sealing surface of cylinder block. 36. Remove speed ring from cylinder block by gently tapping on ring using a hammer and brass drift. T110327B –UN–26JAN98 CED,OUTX547,110 –19–28JUN02–12/22 38. Carefully install stepped side of JDG1264 Speed Ring Installation Tool over speed ring. Seat speed ring using a press or by alternately tapping around the edge of tool with a rubber mallet. Speed ring will be located correctly when tool is bottomed on cylinder block. T119063B –UN–21DEC98 CED,OUTX547,110 –19–28JUN02–14/22 39.
Compress the cylinder block spring using a press and remove the spiral retaining ring. 40. Remove retainer. 41. Remove spring and spring seats. T8492AA –UN–14JUN95 42. Clean cylinder block and components. 43. Assemble cylinder block. TM1859 (14JUL04) 03-0360-13 700H Crawler Dozer Continued on next page CED,OUTX547,110 –19–28JUN02–15/22 071404 PN=203 37. Place new speed ring on chamfered edge of cylinder block. –UN–26JAN98 T110328B CED,OUTX547,110 –19–28JUN02–13/22 03 0360 13